ripngd
******

ripngd supports the RIPng protocol as described in RFC2080.  It's an IPv6 reincarnation of the RIP protocol.

Invoking ripngd
===============

There are no ripngd specific invocation options.  Common options can be specified (see Common Invocation Options).

ripngd Configuration
====================

Currently ripngd supports the following commands:

 -- Command: router ripng
     Enable RIPng.

 -- RIPng Command: flush_timer TIME
     Set flush timer.

 -- RIPng Command: network NETWORK
     Set RIPng enabled interface by NETWORK

 -- RIPng Command: network IFNAME
     Set RIPng enabled interface by IFNAME

 -- RIPng Command: route NETWORK
     Set RIPng static routing announcement of NETWORK.

 -- Command: router zebra
     This command is the default and does not appear in the configuration. With this statement, RIPng routes go to the zebra daemon.

ripngd Terminal Mode Commands
=============================

 -- Command: show ip ripng

 -- Command: show debugging ripng

 -- Command: debug ripng events

 -- Command: debug ripng packet

 -- Command: debug ripng zebra

ripngd Filtering Commands
=========================

 -- Command: distribute-list ACCESS_LIST (in|out) IFNAME
     You can apply an access-list to the interface using the distribute-list command.  ACCESS_LIST is an access-list name.  DIRECT is in or out.  If DIRECT is in, the access-list is applied only to incoming packets.

          distribute-list local-only out sit1